reset(); save(); not clearing code [SOLVED]

[espruino-discuss]

Posted at 2022-10-05 by AdaMan82

I guess I'll post this for others to find since I figured it out as I was making this post.

So despite making sure I don't execute at boot event after reset, I couldn't seem to clear my code from flash without doing E.setBootCode() which I understand might be problematic if my code crashes.

I solved the problem by re-flashing the firmware and it seems to have fixed it.

[espruino-discuss]

Posted at 2022-10-14 by Mrbbp

hello @AdaMan82
sometime pico have strange behavior too and crash with clean code.
reflashing take few seconds than trying to identify uncommon behavior in code is timeconsuming.
i downloaded last firmware to avoid low connexion :)
regards