My code cannot be saved to ESP8266

[espruino-discuss]

Posted at 2017-11-28 by Jessie

After enter "save()" .
It show "Erasing Flash.....
Writing............
Compressed 27200 bytes to 10081
Checking...
Do>"
There is no reaction to this step

---

Attachments:

• QQ图片20171129114530.png

[espruino-discuss]

Posted at 2017-11-28 by Jessie

if use E.setBootCode('...'); then show module 'ws' not found.
Who know how to save?

---

Attachments:

• QQ图片20171129163109.png

---

Posted at 2017-11-28 by Polypod

What do you mean no reaction ? Does your board freeze and become unresponsive to any command?
did you try reset() and load() after your save() ?
The save() work perfectly on my 8266 4mb board. It's only the save-on-send that doesnt.
Do you realize that in your code you do not call send() ?
For external modules, like ws, the code need to be uploaded too, for setBootCode to work. Have a look on the log of WebIDE to see how he send the module code too when you use upload button.
Try flashing a previous version of espruino, like 1.91, 1.92 or 1.93, maybe it will help

---

Posted at 2017-11-28 by Jessie

Thank you very much.
I'll study it.

---

Posted at 2017-11-28 by @allObjects

save() does what it says: saving the code (status of the RAM) intoFllash. When you power-cycle, Espruino restores the code (loads the saved state) and invokes onInit() {...} or E.on("init",function(){...}) registered functions. Personally, I prefer the onInit(){...} because no matter of the code load sequence, I get the sequence I want.

If you do not want to power-cycle, invoke/enter onInit(); from with/in the console, and you get your code started. Read through this conversation about simple explanation how to save code that espruino run on start?.

---

Posted at 2017-11-29 by Jessie

Thank you very much,you let me learn a lot. ^_^

---

Posted at 2017-11-29 by @allObjects

...@jessie, thanks for the feedback, makes my <3 and face :)