Problem with CC2500 and receiver Radiolink R8EF

[DmitriyPopovv]

Good afternoon. I use a 328P chip and CC2500 module, which has only pins - MOSI , SCLK , MISO , CHN.
Pins GD02 , GD00 , PA_EN , LNA_EN module does not have, according to the scheme they should be connected.
/* 1 */ {PROTO_RLINK , RLINK_AIR , 0 , P_HIGH , NO_AUTOBIND , 8 , 0x00000000 },

Problem - the receiver is attached, but there is no stable connection, it does not even work at a distance of 50 cm. Instruments show the transmitter is not producing power.
There may be a problem due to not connecting these pins.
Can this be fixed with tuning bits?

[pascallanger]

Can you post a picture of your cc2500 rf module ?

[DmitriyPopovv]

I also tried with such a module without an amplifier, this one is in receivers Radiolink R8EF, the situation has not changed.
There is a range, the work is not stable, it works like this:
There is a signal for 1 sec, then there is a file safe for 1 sec, there is a signal for 1 sec, then there is a file safe for 1 sec. And so constantly.

[DmitriyPopovv]

Made an assembly on STM32F103 - everything works fine without problems. Why might not work on AVR 328?

[DmitriyPopovv]

EWRF3081 SX2 RF module 2.4GHz RF Module TI-CC2500

This module is used in the remote Radiolink T8FB - EWRF3081