Encrypted RClone Union FS & Move

(Maintained By - Deiteq)

Configure RClone config as Root

Note: This bit can be ignored if using plexguide install

sudo su
rclone config

Configuring RClone

May change due to version | Currently for version 1.38

Part 1 of 3

• N < For New remote
• gdrive < for the name
• 9 < For Google Drive (double check the number select incase)
• Enter Your Google ID
• Enter Your Google Secret
• N < for headless machine #### NOTE: if you're on a VM or the actual machine with an interface (GUI), select Y.
• Enter Your Verification Code
• [Json Question] If you see this, leave it blank and press enter!
• N < Configure this as a team drive?
• Y < If asking all is ok?

Part 2 of 3

• This encrypted mount will be used for the move-en.sh to upload stuff to your Google Drive
• N < For New remote
• gcrypt < for the name
• 7 < For Encrypt/Decrypt (double check the number select in case)
• gdrive:/encrypt (encrypt being the name of the rclone encrypted folder within your gdrive)
• 2 < Encrypt standard
• Y < type your own password (make up a secure one and write it down somewhere safe otherwise use the one from before if you already created it for whichever original encrypted folder you want to use)
• Y < type your own salt password (make up a different secure one and write it down somewhere safe otherwise use the one from before if you already created it for whichever original encrypted folder you want to use)
• Should see something like this:

[gcrypt]
remote = gdrive:/encrypt
filename_encryption = standard
password = *** ENCRYPTED ***
password2 = *** ENCRYPTED ***

• Y < If asking all is ok?

Part 3 of 3

• This encrypted mount will be for unionfs-encrypt.service to avoid bans as it will use plexdrive4
• N < For New remote
• crypt < for the name
• 7 < For Encrypt/Decrypt (double check the number select incase)
• /mnt/plexdrive4/encrypt (encrypt being the name of the rclone encrypted folder within your gdrive)
• 2 < Encrypt standard
• Y < type your own password (use the same password as above for gcrypt)
• Y < type your own salt password (use the same SALT password as above for gcrypt)
• Should see something like this:

[crypt]
remote = /mnt/plexdrive4/encrypt
filename_encryption = standard
password = *** ENCRYPTED ***
password2 = *** ENCRYPTED ***

• Y < If asking all is ok?
• Q < to quit

*********** It is recommended that you restart after this