Technic Hub install

[Martin-Hartwigsen]

Hi, If you install the software on the Technic Hub, there is an instruction to hold the button untill we say to release it. But that instruction never comes, so think it is good to adjust this instruction. All works fine, so no problem. Thanks.

[dlech]

I'm seeing it. Although it isn't as well behaved as it used to be and seems to bounce around a bit or be 1/2 off of the visible area.

[BertLindeman]

Slightly related:

firmware install on robot inventor did not show a "let-go message" on beta.pybricks.com
only erasing old firmware and
installing new firmware

[laurensvalk]

For these hubs it is part of the preparation instructions. You can let it go as soon as it starts blinking.

[Martin-Hartwigsen]

Well, thank you David.....will try again, but pretty sure it was not visible at my Windows 11 laptop.Op 10 feb 2025 16:30 schreef David Lechner ***@***.***>: I'm seeing it. Although it isn't as well behaved as it used to be and seems to bounce around a bit or be 1/2 off of the visible area. image.png (view on web) —Reply to this email directly, view it on GitHub, or unsubscribe.You are receiving this because you authored the thread.Message ID: ***@***.***>