FDYAN160AV1 ducted x50a connector doesn't fit

[lukyjay]

Hi, I have a Daikin Ducted inverter FDYAN160AV1 in Australia. It's about a year old.

I bought an x50a wire but it doesn't fit the port on the board. The plug is too wide and thick.

I couldn't find a port that looks like this, any ideas? Photo supplied

@andi-christ this is the plug from your ebay store. Looks like you sent the right one per the images but the unit might have changed. Any ideas?

[lukyjay]

I can see there's a type F connector on eBay now. Can someone confirm if it's the same pinout, and what connector this is? Thank you

[andi-christ]

Hiya - can confirm that my Type F cable will fit the socket pictured (I'm distributing them through eBay). I'm hand-assembling the cables.

The pinout is the same and the connector is a Molex micro-lock.

[lukyjay]

Thanks so much Andrew. I wish I had checked before ordering but the GitHub wiring page implies the x50a only has one connector so I'll submit a pull request later to show the two. Hopefully that helps others out 🙂

[revk]

Thank you, please do.

[dhruvbhutani]

Hiya - can confirm that my Type F cable will fit the socket pictured (I'm distributing them through eBay). I'm hand-assembling the cables.

The pinout is the same and the connector is a Molex micro-lock.

Apologies if i'm thread highjacking, but would you know if the cable will fit this connector as well? #689

If so, where can I pick up the cable?

[andi-christ]

Hiya - can confirm that my Type F cable will fit the socket pictured (I'm distributing them through eBay). I'm hand-assembling the cables.

The pinout is the same and the connector is a Molex micro-lock.

Apologies if i'm thread highjacking, but would you know if the cable will fit this connector as well? #689

If so, where can I pick up the cable?

Which one? X801?