Question re. MIDI2LR with Loupedeck+ console with Lightroom Classic

[AadNL]

Hi, I'm a newbie to MIDI2LR.
Using my Loupedeck+ console with Lightroom Classic works fine for assigning LR Commands to buttons.
However I've not figured out how to setup the rotating dials. E.g. rotating the main Control dial clockwise is detected as 1:CC48 [1] and counterclockwise as 1:CC48 [127]. I have not found a way to assign separate LR Commands to these rotating directions, either rotation is listed as MIDI Command 1 | CC:48.
Is there a way to assign a LR Command to clockwise rotation and another LR Command to counterclockwise rotation?
Or am I overlooking something more obvious?
Thanks for your attention and reply
Best regards, Aad.

[antzpantz]

Check out this section: https://github.com/rsjaffe/MIDI2LR/wiki/MIDI-Controller-Setup#controllers-that-send-relative-values-or-have-unusual-ranges

…

On Sat, 13 Sept 2025 at 00:42, AadNL ***@***.***> wrote: Hi, I'm a newbie to MIDI2LR. Using my Loupedeck+ console with Lightroom Classic works fine for assigning LR Commands to buttons. However I've not figured out how to setup the rotating dials. E.g. rotating the main Control dial clockwise is detected as 1:CC48 [1] and counterclockwise as 1:CC48 [127]. I have not found a way to assign separate LR Commands to these rotating directions, either rotation is listed as MIDI Command 1 | CC:48. Is there a way to assign a LR Command to clockwise rotation and another LR Command to counterclockwise rotation? Or am I overlooking something more obvious? Thanks for your attention and reply Best regards, Aad. — Reply to this email directly, view it on GitHub <#842>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AFIYPFAMDLIYKQO5GUU5MR33SLZWDAVCNFSM6AAAAACGLQSM6OVHI2DSMVQWIX3LMV43ERDJONRXK43TNFXW4OZYHA4DOMBXGI> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>

[AadNL]

Thanks @antzpantz, I did read that section and now re-read it. However, even after Adjusting the CC dialog for LR Command 1:CC48 to Two's complement (based on returned values 1 and 127), I still am left with only on 1|CC48 MIDI Command entry for either value 1 or 127. Would have hoped to be able to assign another LR Command to the other value.
@antzpantz after setting the CC dialog to Two's complement and disabling the Pick Up Mode, the dial controls now work both ways, but are immediately set to the minimal resp. maximal values. Is there a way to have small increments?