Version
1.2.9
Operating system type + version
Fedora 25 x86_64
Behavior
When the STL file is imported, all dominoes are sliced properly. When I press the "Split" icon, the dominoes are correctly split into separate pieces. However, some of the dots on the top of the dominoes get covered over with solid filament, only on the very top layer.
STL file and config attached, along with source OpenSCAD file and preview screenshots from before/after splitting operation.
STL/Config (.ZIP) where problem occurs
split_issue.zip
Version
1.2.9
Operating system type + version
Fedora 25 x86_64
Behavior
When the STL file is imported, all dominoes are sliced properly. When I press the "Split" icon, the dominoes are correctly split into separate pieces. However, some of the dots on the top of the dominoes get covered over with solid filament, only on the very top layer.
STL file and config attached, along with source OpenSCAD file and preview screenshots from before/after splitting operation.
STL/Config (.ZIP) where problem occurs
split_issue.zip