Setup parameters in Epever

[PrebenPayne]

Hello, is it possible to set up the parameters internally in Epever via Epever2mqtt?

[softwarecrash]

actual no
only load control and set time

[nobbystyles]

Although I think a have appropriate settings I understand that there is nothing that can be done. My settings just for information below. Thank you.
BatType: 0
BatCap: 280
TempComp: -3
OVCutOff: 29,00
ChargLmt: 28,00
OVRcv: 27,00
EquilV: 27,40
RaisV: 27,40
FloCharg: 27,00
RaisRcv: 26,90
LVRcv: 22,00
WarnRcv: 25,00
LVWarn: 24,00
LVCutOff: 21,00
DischaLmt: 20,00
RatedLv: 1
EquilDur: 1
RaisDur: 15
BatDisch: 30
BatCharg: 80
ChargMode: 0
LiBatteryProtection2: 0
DropPower: 1
Controlsignal: 1

[PrebenPayne]

Try to set FloCharg to 27.50 then I think SOC will drop

[nobbystyles]

Trying to set the Float_Volts to 27.5 via MQTT is not accepted in my case. First the new value turns red then it reverts to 27.

[PrebenPayne]

Ok, probably because there are internal rules for the settings, meaning maybe Float volts cannot be higher than EquilV: 27,40 and RaisV: 27,40. So maybe setting to 27.4 or 27.3 is allowed

[nobbystyles]

Same behaviour - as you wrote I think internal rules do their work, too ... it is not a real problem because I can look up (and change) the SOC in my "Daly2MQTT-device (BMS)" and take this value as reference.