Adding Victron Smart MPPT RS 450/200

[dandoart]

Would it be possible to add the following device in the next release?
(VE.Direct Protocol for Blue Solar and SmartSolar MPPT chargers , )

0xA110 - Smart Solar MPPT RS 450/100 (2 MPPT trackers)
0xA1111 - Smart Solar MPPT RS 450/200 (4 MPPT trackers)

Most intresting are the detailed string details ( individual MPPT tracker registers)

Register: 0x0244 to determine how many trackers the MPPT RS supports
Attached a picture containing all the register for all 4 trackers.

Thanks in advance, Daniel

[softwarecrash]

hello,
victron2mqtt support only the ve.direct protocol.
the VE.Direct protocol doenst support registers (modbus) what shown in your picture

[dandoart]

Hello,
the registeres are out of the document: "VE.Direct Protocol for Blue Solar and SmartSolar MPPT chargers".
This has more registeres than the standard VE.Direct-Protocol-3.33 document.

BlueSolar-HEX-protocol.pdf

Page 5 and page 14 contains the information.
VE.CAN is hopefully a different document?

[softwarecrash]

ve.direct and ve.hex a different communication forms from victron, victron2mqtt actual only support ve.direct, not ve.hex or ve.can

[dandoart]

thanks for clarification, it was not obvious to my non programmmer knowledge,
the standard values work with the victron2mqtt. you get total power and battery voltage.
Does it make sense to add the MPPT RS 450/200 to your device list? Maybe with a remark "rudimentay values support"
It runs stable since 5 days. Thanks a lot Daniel

[softwarecrash]

no problem,

all the devices with a ve.direct port works great, the recived data is deepend on the device model and what data it gives, badly there is no way to get more data as the given over the ve.direct. when you need more, try a look at other projects that support ve.hex or can variants