Update Nucleo-64 Known limitations

to avoid any confusion

See #10

Signed-off-by: Frederic.Pillon <[email protected]>

Author: fpistm

README.md

@@ -33,8 +33,12 @@ as a simple LoRa® radio module.
   Those pins are connected to STLink USART thanks to SB13, SB14.
 
   To use the shield:
-    - Connect shield D0(Tx) to PC11(Rx)
-    - Connect shield D1(Rx) to PC10(Tx)
+    - Connect shield D0(Tx) to a free U(S)ARTn Rx pin
+    - Connect shield D1(Rx) to a free U(S)ARTn Tx pin
+
+  Where 'n' are the same U(S)ART number.
+
+    - Update the Serial instance definition used for LoRa using the chosen Rx/Tx
 
   or
 

examples/BridgeSerial/BridgeSerial.ino

@@ -10,8 +10,11 @@
   Those pins are connected to STLink USART thanks to SB13, SB14.
 
   To use the shield:
-    - Connect shield D0(Tx) to PC11(Rx)
-    - Connect shield D1(Rx) to PC10(Tx)
+    - Connect shield D0(Tx) to a free U(S)ARTn Rx pin
+    - Connect shield D1(Rx) to a free U(S)ARTn Tx pin
+  Where 'n' are the same U(S)ART number
+    - Update the below 'SerialLora' instance definition using the chosen Rx/Tx
+
   or
     - Close SB62 and SB63 to connect D0/D1 of CN9 connector to PA3 and PA2
     - Open SB13 and SB14 to disconnect PA3 and PA2 from STLink UART

examples/getInfo/getInfo.ino

@@ -10,6 +10,7 @@
 
 // Serial port use to communicate with the USI shield.
 // By default, use D0 (Rx) and D1(Tx).
+// For Nucleo64, see "Known limitations" chapter in the README.md
 HardwareSerial SerialLora(D0, D1);
 
 void setup()