You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hi, Im using a Aoqee C1 camera which I could only get to flash via an unbrick firmware first then changing to the lastest one aoqee_c1_t23n_sc2336_atbm6062cu-3.10 (firmware-2026-02-02). All is good I can see the feed etc via RTSP but if I change any setting for the main or sub stream the RTSP fails. Even if I change the setting back. The only way I can get RTSP feeds to work is by using firmware dated 2026-01-19 or older.
Also under settings-RTSP/ONVIF it says "Configure the day/night automation thresholds and the controls it toggles."
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
Uh oh!
There was an error while loading. Please reload this page.
-
Hi, Im using a Aoqee C1 camera which I could only get to flash via an unbrick firmware first then changing to the lastest one aoqee_c1_t23n_sc2336_atbm6062cu-3.10 (firmware-2026-02-02). All is good I can see the feed etc via RTSP but if I change any setting for the main or sub stream the RTSP fails. Even if I change the setting back. The only way I can get RTSP feeds to work is by using firmware dated 2026-01-19 or older.
Also under settings-RTSP/ONVIF it says "Configure the day/night automation thresholds and the controls it toggles."
Beta Was this translation helpful? Give feedback.
All reactions