Getting lots of "Unknown command: G17" after updating to v00.04-beta

[DougJoseph]

Ever since updating to v00.04-beta, I get lots of "Unknown command: G17."

It seems to have to do with setting a plane (for handling arcs?).

I was not seeing this while on the v00.03 beta.

I did not change my slicer config. Any ideas?

[Tiwatz]

Set z-hop to "normal" in Orca slicer.

[DougJoseph]

Thanks. Have made the change and will test when the current print job finishes!

[DougJoseph]

PS: To do this in OrcaSlicer, for anyone reading who does not know:

Click on the printer name in the upper left corner, then click the "Extruder" and look for the "Retraction" section.

[consp]

Ever since updating to v00.04-beta, I get lots of "Unknown command: G17."

That was probably due to the alpha containing newer klipper code which already allows G17 (I mixed two versions accidentally), since that code is not (yet) included it will give you those "errors". It's not really an issue though, just annoying.

[DougJoseph]

Got it. Thanks!