TMC 'extruder' reports error: GSTAT: 00000001 reset=1(Reset)

[fernplant]

Have had this error come up a few times recently and print gets aborted. Anyone else have this?

[fernplant]

Update:

Had been getting this error more and more frequently. I had seen from others online that this was often the result of an issue with loose or damaged wiring. I took apart extruder to expose PCB, unplugged main 24V cable and plugged back in. Noticed chafing on the insulation of the main cable at the plastic swivel at the top of the extruder, had not yet rubbed through but was on its way. I loosened the cable clamp at back of extuder and pulled cable further into housing which seems to have made it now so it doesnt rub on the plastic.

With that done, no more error (for now). Hopefully it stays good 🤞

Edit/Update to the update: Sadness. Same error again after about 15 hours of printing :( Still an issue with something