Auto flowrate calibration

[davimazz]

Hello all, i truly hope someone can help me.
Every print I start, no matter what temperatures I set in orca before slicing, my printer changes to 200 for the hotend and 60 for the bed, then runs what i think is an auto flowrate calibration (prints a couple of lines at the front of the build plate) before continuing to print.
It is at this point I can manually turn the temperatures back to what they should be.
How do I stop this happening? Can I completely disable it?
Iv looked through my gcodes and through printer.cfg and cant find anything, and tried removing and reinstalling klipper mod but the issue persists.
Any help would be greatly appreciated.

[Tiwatz]

Probably your start and end g-code in Orca.

[davimazz]

This is my start gcode

START_PRINT
BED_TEMP={first_layer_bed_temperature[0]} EXTRUDER_TEMP={first_layer_temperature[0]}

[Tiwatz]

I think it all needs to be on one line.

[davimazz]

Absolute legend. You have no idea how annoyed I was getting. Thank you mate 👍🏻