drivers: wifi: winc1500: Fix wifi module so that it is not held in reset.

The "nm_bsp_reset" is used to apply a hard reset to the WINC board by
setting CHIP_EN and RESET_N signals low,then after specific delay
the function will put CHIP_EN high then RESET_N high.
reset-gpio is however defined as active low , causing this function
to hold the wifi module in reset.

Signed-off-by: Andreas Ålgård <[email protected]>

Author: icsys-aal

drivers/wifi/winc1500/wifi_winc1500_nm_bsp.c

@@ -52,13 +52,13 @@ int8_t nm_bsp_deinit(void)
 void nm_bsp_reset(void)
 {
 	gpio_pin_set_dt(&winc1500_config.chip_en_gpio, 0);
-	gpio_pin_set_dt(&winc1500_config.reset_gpio, 0);
+	gpio_pin_set_dt(&winc1500_config.reset_gpio, 1);
 	nm_bsp_sleep(100);
 
 	gpio_pin_set_dt(&winc1500_config.chip_en_gpio, 1);
 	nm_bsp_sleep(10);
 
-	gpio_pin_set_dt(&winc1500_config.reset_gpio, 1);
+	gpio_pin_set_dt(&winc1500_config.reset_gpio, 0);
 	nm_bsp_sleep(10);
 }