Heal network - how long?

[drjjr2]

When I attempt to heal my network it gets as far as "Healing process IN PROGRESS. Healed 2 nodes" and then seems to stop. The debug window does not show any activity. I have the log level set to Debug.

[robertsLando]

@AlCalzone ?

[AlCalzone]

It can take several seconds up to a few minutes per node and you have to wake up battery-powered nodes to heal them. I'm not sure what exactly zwavejs2mqtt displays during the heal. It makes sense to show which nodes are skipped/healed/waiting.

[robertsLando]

It should be shown in controller status as it progress

[drjjr2]

What's the timeout for a sleeping node? I will say that the next node in line is an ECOLINK door/window sensor. But even when I open the door it still says "Asleep" in the status.

[AlCalzone]

There's no timeout. And opening the door will most likely not wake up the sensor. Check your manual how to do that (probably involves taking it apart and pressing some button.

[drjjr2]

OK, did that, they show "Awake" and I'm still stuck at "Healed 2 nodes"
Is there a log I can view to help figure this out?