SDMMC on esp32 s3 reboot

[IXNDR]

When arming my plane and sdmmc is enabled, it will reboot the esp.
Used madflight-v2.3.1-dev
ESP32 v3.3.7

`RDR: NONE
OFL: NONE
GPS: NONE
ALT: KALMAN3 altCov=0.200000 accCov=0.010000 biasCov=0.100000
AHR: MAHONY
IMU: MPU6500
IMU: IMU_EXEC_FREERTOS
AHR: No Magnetometer, yaw:0.00
Calibrating gyro, don't move vehicle, this takes a couple of seconds...
set imu_cal_gx -5.809094 #config was +0.000000
set imu_cal_gy -7.096904 #config was +0.000000
set imu_cal_gz -0.416330 #config was +0.000000
Type 'save' to save these values to flash
CLI: WARNING Serial transmit buffer (128 bytes) is small
OUT: idx:gpio:type = 0:G4:PWM 1:G5:Servo 2:G6:Servo 3:G7:Servo 4:G15:Servo 5:G16:Unused
Setup completed, CLI started - Type 'help' for help, or 'diff' to debug
OUT: ARMED
Guru Meditation Error: Core 1 panic'ed (Unhandled debug exception).
Debug exception reason: Stack canary watchpoint triggered (mf_BBX)
Core 1 register dump:
PC : 0x4205c57b PS : 0x00060b36 A0 : 0x820578d2 A1 : 0x3fced300
A2 : 0x3fced4f4 A3 : 0x3fced620 A4 : 0x3fced310 A5 : 0x3fced6c0
A6 : 0x3fced6a0 A7 : 0x0000000c A8 : 0x000001e4 A9 : 0x3fced310
A10 : 0xffffffff A11 : 0x3c07250b A12 : 0x000000ff A13 : 0x0000ff00
A14 : 0x00ff0000 A15 : 0xff000000 SAR : 0x00000010 EXCCAUSE: 0x00000001
EXCVADDR: 0x00000000 LBEG : 0x400570e8 LEND : 0x400570f3 LCOUNT : 0x00000000

Backtrace: 0x4205c578:0x3fced300 0x420578cf:0x3fced620 0x42048140:0x3fced6e0 0x42048cb2:0x3fced700 0x4203cf87:0x3fced850 0x42059085:0x3fced870 0x42027187:0x3fced890 0x420273f1:0x3fced8b0 0x4202755f:0x3fced8f0 0x42026af1:0x3fced930 0x4200c407:0x3fced960 0x4200c6e8:0x3fceda10 0x4200ab36:0x3fceda30 0x4200acd8:0x3fceda70 0x4037c3bd:0x3fceda90

ELF file SHA256: 1b1f660bb

Rebooting...`