You only have a limited time for the printer to be paused before it shuts down all steppers and heaters. BAD CONFIG

[Erosion139]

I had the printer pause for filament runout last night and this morning I came to the printer with its motors disabled and build plate cooled down. Config is bad please fix for future installs.

[fernplant]

Check your timeout value. You can set it to whatever you'd like

[Erosion139]

Check your timeout value. You can set it to whatever you'd like

Yeah I corrected it but this is something that should have been mitigated in the default configuration since everything else seems to be very well setup and configured with all the features. I just want to help make first time users have a good experience.

This occurs during filament runout by the way, the steppers will disable if you're not there to replace the filament within the window. This doesn't happen in other default klipper installs I've used or created myself so I'm not sure where the issue presents itself where it thinks it can safely disable the steppers during a pause.

And to be crystal clear, the solution is not setting timeout. Because in other klipper installs, timeout is not started when you pause a print.