There are two zip files in this release. They contain the firmware versions with which the latest release of RFSoC Explorer has been tested. Be aware that this is not necessarily the latest MicroZed firmware. The latest firmware for the MicroZed should always be obtained from your Fujikura repository, which is provided by Fujikura after NDA.
The file that starts with "ZCU208" contains the files that go on the ZCU208 Micro SD card. Please follow this link for instructions:
https://github.com/Avnet/Fujikura-beamforming#usd-card-preparation
Note that this Zynq boot image was created using the AMD Vivado/Vitis 2020.2 tools.
The file that starts with "MicroZed" contains the files that go on the Micro SD card on the MicroZed that plugs into the Fujikura Type-C PAAM Evaluation Board (EVB).
Use only the three files in the .zip file.
Place the BOOT.bin file and the uz_network_settings.txt file on the MicroZed uSD card.
If necessary, the IP address and port number can be edited in uz_network_settings.txt.
The version.txt is not necessary, but is useful because it shows the firmware versions involved.
The BOOT.bin file in this release should reflect the following versions on power-up:
Zynq PL design 0, ver 0.5.0; c9b3175b Timestamp 2025.03.25 17:29:27
Zynq PS design 0, ver 0.5.0; 423315b1 Timestamp 2025.04.08 17:22:49