Pocketqube Command and Data Handling Board

Pocketqube command and data handling board

Dependencies

sudo apt install build-essential cmake gcc git libusb-1.0-0 libusb-1.0-0-dev libgtk-3-dev
cd $HOME/git-repos/cote/scripts
./setup_dependencies.sh $HOME/sw

Useful link

• libopencm3 : STM open source firmware link

Directory Contents

• 3d-models: Contains copies of .stp 3D model files
• components: Contains copies of .lib component files
• datasheets: Contains component datasheets
• footprints: Contains copies of .kicad_mod footprint files
• gerbers: Contains the most recent set of Gerber files
• kicad: Contains the KiCad project files
• versions: Contains .zip files of Gerber files submitted for manufacture
• BOM.csv: Bill of materials
• LICENSE: License
• NOTES.md: Step-by-step instructions for setting up KiCad, designing the board, and exporting Gerber files for manufacture
• README.md: This document

License

Written by Bradley Denby
Other contributors: None

Update

PQ-CDH Version 0.1.0 :

1. Transferred design scheamtic and PCB from Kicad5 to Kicad6
2. Mounting holes adjustment same as referred to comm-401 board.
3. Reduced board dimension 43 x 43 mm
4. Removing 5th Pin from upper and lower right

PQ-CDH Version 0.1.1

1. Changed VDD, GND, SWDIO, and SWCLK to lower left to right 4 pins
2. Changed "PQ CDH v0.1.0" to "PQ CDH v0.1.1"
3. Adjusted controller and Conn_02x06_Odd_Even, for mounting hole clearance.
4. Adjusted Conn_02x06_Odd_Even in vertically aligned along with aligned to top and bottom connector holes.
5. Addition of 4 testpads added between oscillator and its capacitor.

PQ-CDH Version 0.2.0

1. I2C3 SDA and SCL to pins 1 and 2 on the bottom header row
2. ADC to pin 3 on the bottom header row
3. unused GPIO to pins 4 and 5 on bottom header row

See the top-level LICENSE file for the license.