Emulates Hörmann UAP1-HCP board (HCP2= Hörmann communication protocol 2) using an ESP32 and a RS485 converter, and exposes garage door controls over web page and MQTT.
Compatible with the following motors (UAP1-HCP / HCP2-Bus / Modbus):
- SupraMatic E/P Serie 4
- ProMatic Serie 4
- Rollmatic v2
It is not compatible with E3 series motors. Previous generations have different protocol (HCP1), different pin layout, and already have another supporting project (see hgdo, hoermann_door or hormann-hcp).
- Get current status (door open/close/position, light on/off)
- Support for ESP32-S1/S2/S3
- Support multiple HCP Bridges for multiple garage doors
- HomeAssistant integration via MQTT-AutoDiscovery
- Trigger actions via Webinterface
- light on/off
- gate open, close, stop
- gate position: half, ventilation, custom (MQTT set_position compatible)
- Configuration (Wifi, MQTT, ...) via Web Interface
- Web Service API
- OTA Update (with username and password)
- First Use Hotspot for configuration
- External (optional) sensor support (threshold orientated MQTT messages):
- DS18X20 temperature sensor
- BME280 temperature and humidity sensor
- DHT22 temperature and humidity sensor
- HC-SR04 proximity sensor (car (below) detection)
- HC-SR501 PIR motion sensor
- Efficient MQTT traffic (send only MQTT Message if states changed)
http://[deviceip]
