About this Release

This release supports the following Switchtec devices and releases:

Generation	Variant	Release
Gen5	PFX/PSX	FCA (F/W version: 06.01.0.01f)
Gen4	PFX/PSX	MR-1 (F/W version: 03.60.0.049), MR-2 (F/W version: 03.70.0.04f), MR-3 (F/W version: 03.80.0.056), MR-4 (F/W version: 03.90.0.05b)
Gen4	PAX	MR-1 (F/W version: 04.60.0.449), MR-2 (F/W version: 04.70.0.450), MR-3 (F/W version: 04.80.0.456), MR-4 (F/W version: 04.90.0.45b)

What is New Since v3.0 Release?

This release introduces the following new features, changes and fixes

diag submenu: added the following new diagnostic commands
       eye: display eye diagram of a port
        crosshair: measure eye cross hair of a port
        list-mrpc: list permissible MRPC commands
        loopback: enable loop back test on specified ports
        pattern: enable pattern generation and monitor
        port-eq-txcoeff: dump port equalization coefficients
        port-eq-txfslf: dump FS/LF output data
        port-eq-txtable: dump far end port equalization table
        rcvr-extended: dump RX mode and DTCLK
        rcvr-obj: dump analog RX coefficients/adaptation objects
        refclk: enable or disable the output reference clock of a stack
        ltssm-log: display LTSSM log
log-dump: added Event ID field in text log files
fw-read: changed default output file name to image.fwimg for Gen4 and later devices

status: fixed segmentation fault found on ARM platform only
log-parse: fixed missing Firmware/SDK version number when parsing mailbox log files

GAS dump
Switchtec-user command gas dump might impact system performance or cause instability
FABRIC commands
fabric submenu commands are not yet supported on Gen5 device
DIAGNOSTIC commands
diag submenu command are for Gen4 device only