Add onboard LED for XIAO S3 #196
Draft
Conversation
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
|
double check if it's not opposite low-high, or some funny pull situation, as just seen it do the LED flash after being on a while, and then get apparently stuck on. It's almost like it's on until the next blink phase. Then looking again it's now off, but very weakly on, while writing this message, but very weakly on when looked at closely. Few mins later, been on then blinked at next ping then stuck on again, but weakly changing when wifi busy, or changing strongly off/on when a kattni blink. |
|
That behaviour might actually be legit adafruit/Adafruit_Wippersnapper_Arduino#768 (comment) |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
Be nice to add this to magic config too, so users can get some visual output with no extra hardware.