Put all the libraries contained in the 'libraries' folder into your local arduino library folder. You can find the location of this folder from File>Preferences>Sketchbook location.

Board: Arduino Mega Processor: atmega2560

---

Use code under 'PRODUCTION V1' , all other versions are archives.

In Pinout.h select type of machine: Either #define AUDI_V2 for motherboard rev2 Or #define SHIELD_V3 for motherboard rev3

---

If machine gives error code or does not connect, set PYTHON=0, you can then connect over Serial Port with machine.

TURN PYTHON ON (1) OR OFF (0):

#define PYTHON 1

---

WHEN INITIALISATION FAILS, STOP MACHINE (1) OR CONTINUE ANYWAYS (0):

#define HARDWARE 1

USE I2C (UNCOMMENT LINE) OR SPI (COMMENT LINE) HALL SENSOR:

#define hall_sensor_i2c  

TURN PRESSURE SENSOR IN TUBE ON (1) OR OFF (0):

#define BME_tube 1

TURN AMBIENT PRESSURE SENSOR IN CASE ON (1) OR OFF (0):

#define BME_ambient 0