Skip to content

Releases: eh2k/squares-and-circles

RC_0.0m

RC_0.0m Pre-release
Pre-release

Choose a tag to compare

@eh2k eh2k released this 04 Sep 08:29

RC_0.0m

  • New Engines:
    • CV:Noise (White/Pink Noise)
    • FX:ReverbSC (8 delay line stereo FDN reverb, based on work by Sean Costello)
  • Enhancements:
    • CV:V/OCT - Slew
    • Modulations:
      • CV-OP (Sample&Hold, Track&Hold) #16
      • Pitch-Modulation is routed through the internal CV-In quantizer
  • Optimizations
    • ADC: less noise, equal samplerate on all Inputs ( recalibration of the ADCs recommended )
    • SPI: DAC/Display - less interference / higher display-rate (20 fps)
    • Support DAC_8564/DAC_8565 #13 (Setup-Commands WebFlasher)

Please use the WebFlasher to flash the firmware directly from the browser (tested with Chromium):

...have fun jamming!

RC_0.0l

RC_0.0l Pre-release
Pre-release

Choose a tag to compare

@eh2k eh2k released this 25 Jul 20:38

RC_0.0l

  • Optimizing/Refactoring "integer" output
    • BugFix: CV:V/OCT output was allways 0V
    • BugFix: M-OSC:Waveforms distorted output (gain x 4)
  • Midi processing
    • BugFix midi config (midi on tr1) was reset, after io config tr
    • BugFix: Midi to Accent conversion (not working on CH+OH)
    • ControlFrame.clock refactoring - clock 1-96...
  • BugFix: tuning offset on the synth machines #14 DAC 48kHz now ( before 50kHz )
  • Press [R] on startup - reset preset
  • Screensaver #12 after 5min

Please try the following link to flash the firmware directly from the browser (tested with Chromium):

WebFlasher

...have fun jamming!

RC_0.0k

RC_0.0k Pre-release
Pre-release

Choose a tag to compare

@eh2k eh2k released this 30 Jun 07:28

Changes (see also updated project README):

  • Lowlevel refactorings
    • USB-Midi enabled
    • Midi settings relocated to a separate "Midi-Settings" page -> press left+right
      • Hint: Shortcut for "patch saving" changed to "press both encoders"
      • if no midi clock, an internal clock is active ( BPM settings)
    • Trigger/CV behavior
      • In Addition to the trigger, a configurable "accent" event was introduced (eg. for Closed/Open HiHits)
      • all inputs (TR+CV) can be used as triggers or accents
      • optimized trigger-rising-edge detection on CV input
    • Modulations refactoring
      • Sample&Hold removed...
      • Modulation trigger configuration relocated as modulation-parameter (T1-4,C1-4, '!' = default engine trigger)
  • Engines
    • New:
      • Midi/Monitor,
      • Midi/Clock,
      • Midi/VAx6 (6-Voice Virtual Analog, only controlled by MIDI)
    • Optimizations/Cosmetics:
      • Drums/TR909-Ride - trigger+accents ..
      • M-OSC/Chord - chord selection by name (17 JON_CHORDS)
      • FX/Delay - delay time by midi clock / internal clock
      • Here and there optimized parameter ranges... (HiHats/Samples)

With the 0.0k version, the patch memory block has changed, consequently old patches cannot be loaded in some cases.
A message "PATCH restore failed..." should appear. The calibration memory block is not affected.


Please try the following link to flash the firmware directly from the browser (tested with Chromium):

https://eh2k.github.io/□●/flash/?ver=RC_0.0k

...have fun jamming!

0.0.0

0.0.0 Pre-release
Pre-release

Choose a tag to compare

@eh2k eh2k released this 29 Nov 20:34

0.0.0