Argon ONE fan script for DietPi

These installation steps are specific to the DietPi operating system on Raspberry Pi and will enable you to use the fan and button behaviour as intended on the [Argon ONE mini Case] (https://argon40.com/products/argon-one-v2-case-for-raspberry-pi-4)

Required software packages:

• Pytyhon 3 [130]
• Python 3 RPI.GPIO [69]
• I2C [72]

use 'dietpi-software' to install missing software packages

Required hardware settings:

use 'dietpi-config' then 'Advanced Options' to enable required hardware

• Serial/UART -> ttyS0 | toggle On
• I2C state | toggle On

alternatively you can run the following lines in the terminal:

• sudo /boot/dietpi/func/dietpi-set_hardware i2c enable
• sudo /boot/dietpi/func/dietpi-set_hardware serialconsole enable

 

Install Argon ONE deamon and config

Now the system is ready to run the install script. 1st option is to use the last version known to be working. 2nd option is to run the latest version directly from the Argon40 website.

Run from terminal

Last version known to be working

• curl https://raw.githubusercontent.com/gwylanscheeren/argonone_dietpi/master/argon1.sh | bash

Latest version directly from Argon40 website

• curl https://download.argon40.com/argon1.sh | bash

Add service to DietPi managed services

go to dietpi services configuration by entering in terminal:

dietp--services

'Add' argononed go to new service 'argononed' entry and 'Include' into list of services managed by DietPi.

That's it. Enjoy your Argon One case fan and buttons.

 

Change fan settings:

Run from terminal:

• argone-config