Python asyncio LD2410 Library

aio-ld2410 is a python library that allows interacting with the Hi-Link LD2410 sensors using asyncio.

Such radar sensors would typically require a USB-UART adapter on most computers but UART is natively supported on most embedded platforms such as the Raspberry Pi.

This library supports a wide range of variants in terms of models and firmware versions, but was mostly tested on LD2410C with firmware v2.04.23022511.

It features comprehensible methods to get and set various configuration parameters, as well as dataclasses for output results and sensor reports.

Installation

This package requires Python ≥ 3.9 and pulls a few other packages as dependencies.

To install aio-ld2410, simply run the following command:

python -m pip install aio-ld2410

Usage

Here's how you can start reading sensor reports from a few lines of python:

#!/usr/bin/env python

import asyncio
from aio_ld2410 import LD2410

async def main():
    async with LD2410('/dev/ttyUSB0') as device:
        async with device.configure():
            ver = await device.get_firmware_version()
            print(f'[+] Running with firmware v{ver}')

        # Reports are typically generated every 100ms.
        async for report in device.get_reports():
            print(report)

asyncio.run(main())

For further details, please refer to the documentation.

Contributing

Contributions, bug reports and feedback are very welcome, feel free to open an issue, send a pull request. or start a discussion.

Participants must uphold the code of conduct.

aio-ld2410 is released under the MIT license.