-
-
Notifications
You must be signed in to change notification settings - Fork 2
CAN to Inverter Connection
Si Jones edited this page Jun 7, 2024
·
1 revision
Each Inverter has it's own connection method, the manual for the Inverter should identify how to connect to it.
There is only 2 wires required, CAN H and CAN L, although some have a Ground available there is no need for it to be connected.
The Inverter should have a RJ45 connector port on it, using a normal Cat5 patch cable with one end cut off can work for an easy solution.
On a Solis Inverter the RJ45 Pins 4 and 5 are used, Pin 4 being H and Pin 5 for L.
It's recommended to use a isolated CAN Bus adapter, the one I would recommend is:
The wiring is the same as the other one mentioned on the how to wire CAN Bus adapter, but this has 2 CAN Interfaces, therefore ignore the second one and also don't need to wire the second INT and CS pins.