i2c: Add I2C Controller implementation

Cargo.toml

@@ -87,3 +87,7 @@ opt-level = "s" # optimize for binary size
 [[example]]
 name = "blinky"
 required-features = ["stm32h503"]
+
+[[example]]
+name = "i2c"
+required-features = ["stm32h503"]

examples/i2c.rs

@@ -0,0 +1,64 @@
+#![deny(warnings)]
+#![no_main]
+#![no_std]
+
+#[macro_use]
+mod utilities;
+use embedded_hal::{delay::DelayNs, i2c::I2c};
+use fugit::SecsDurationU32;
+use stm32h5xx_hal::{delay::Delay, pac, prelude::*};
+
+use cortex_m_rt::entry;
+
+use log::info;
+
+#[entry]
+fn main() -> ! {
+    utilities::logger::init();
+    log::set_max_level(log::LevelFilter::Debug);
+    let cp = cortex_m::Peripherals::take().unwrap();
+    let dp = pac::Peripherals::take().unwrap();
+
+    // Constrain and Freeze power
+    info!("Setup PWR...                  ");
+    let pwr = dp.PWR.constrain();
+    let pwrcfg = pwr.freeze();
+
+    // Constrain and Freeze clock
+    info!("Setup RCC...                  ");
+    let rcc = dp.RCC.constrain();
+    let ccdr = rcc.sys_ck(100.MHz()).freeze(pwrcfg, &dp.SBS);
+
+    let gpiob = dp.GPIOB.split(ccdr.peripheral.GPIOB);
+
+    let mut delay = Delay::new(cp.SYST, &ccdr.clocks);
+    let duration = SecsDurationU32::secs(1).to_millis();
+
+    // Configure the SCL and the SDA pin for our I2C bus
+    let scl = gpiob.pb5.into_alternate_open_drain();
+    let sda = gpiob.pb3.into_alternate_open_drain();
+
+    info!("");
+    info!("stm32h5xx-hal example - I2C");
+    info!("");
+
+    let mut i2c =
+        dp.I2C2
+            .i2c((scl, sda), 100.kHz(), ccdr.peripheral.I2C2, &ccdr.clocks);
+
+    // The STM32H503 NUCLEO board does not have any I2C peripherals, so put in the address of
+    // whatever peripheral you connect
+    let device_addr: u8 = 0x18;
+    // This implements a typical 8-bit register read operation, writing the register address and
+    // then issuing a repeat start to read the register value. Tweak these settings to read the
+    // desired amount of bytes from the register address.
+    let register_addr = 0x02;
+    let write = &[register_addr];
+    let mut read = [0u8; 1];
+
+    loop {
+        i2c.write_read(device_addr, write, &mut read).unwrap();
+        info!("Read reg {register_addr}: {read:X?}");
+        delay.delay_ms(duration);
+    }
+}