hwdef: remove MatekL431-Periph

[peterbarker]

this was a kitchen-sink AP_Periph build. We're moving away from these.

This board does not currently build. We could make it build, but it will die again and again.

[tpwrules]

In fairness the MatekL431 node is a kitchen sink kind of board. I will miss this build dearly 😭

Why is a speedybee change mixed in?

[IamPete1]

That is for this board:
https://www.mateksys.com/?portfolio=can-l431#tab-id-1

This build is recommended on there page?

I have used these a lot. Typically as a base with extra stuff added on, relay temp sensors ect.

I think we should fix it rather than removing. Maybe remove GPS, I think remote GPS via a external node is not common.

[andyp1per]

Maybe remove GPS, I think remote GPS via a external node is not common.

Yes, agreed

[tpwrules]

I looked and it does seem GPS changes are what pushed it over the edge. Can we just remove some of the rarer GPS types? It does have a GPS plug and a GPS is a suggested application. But maybe we could push users to the GPS-specific build for that.

[tpwrules]

#27685 will bring this build back from the dead without any hwdef changes.

[joshanne]

+1 for keeping this build around. As Pete mentioned, that board is a kitchen sink board. I tend to rely on the base hwdef to customise this board.

Edit: Tested @tpwrules changes, and MatekL431 is brought back to life.

[Ryanf55]

You can drop GSOF from periph on this board as long as we still check GSOF on Periph.

[peterbarker]

OK, obviously a lot of love for the MatekL431-Periph build. Lesson learnt :-)